Currently Empty: €0,00
-€0,63
3.7V lithium battery protection board overcharging over discharge current of 2A apply lithium polymer battery
€1,72
Attualmente disponibile su ordinazione con consegna prevista entro 60 giorni circa dall'acquisto.
| Quantità | Prezzo Unitario |
|---|---|
| 12 - 49 | €1,67 |
| 50 - 99 | €1,64 |
| 100 + | €1,55 |
Product Description
3.7V lithium battery protection board overcharging over discharge current of 2A apply lithium polymer battery
Description:
- This Board is used to protect lithium cells from Full Discharge, Over-Charging, Over-current and Short Circuit
- Suitable for Lithium Batteries with nominal voltage of 3.6V, 3.7V, 3.8V and charge up to 4.2V per cell
- Need basic soldering skills to wire the board
- Input voltage: 4.2V regulated from Constant Current and Constant Voltage source
- Board is very small – 22x4x3mm
Welding points:
B+ : Battery Positive
B- : Battery Negative
P+ : Charger/Load Positive
P- : Charger/Load Negative
Parameters table:
| No. | Parameter | Nominal Values | |
| 1 | Voltage | Charging voltage | DC: 4.2V CC / CV |
| Single balanced voltage | n/a | ||
| 2 | Electric current | Single equalizing currents | n/a |
| Single battery consumption (self-consumption) | n/a | ||
| Maximum continuous discharge current | n/a | ||
| 3 | Overcharge protection | Overcharge detection voltage | 4.275 V ± 0.025V |
| Overcharge detection delay time | 150-500 ms | ||
| Overcharge recovery voltage | 4.075V ± 0.025V | ||
| 4 | Over-discharge protection | Overdischarge detection voltage | 2.45V ± 0.1V |
| Over discharge detection delay time | 50-150ms | ||
| Over-discharge recovery voltage | 2.9V ± 0.10V | ||
| 5 | Overcurrent protection | Overcurrent detection voltage | 150 ± 30mv |
| Over current detection current | 2 ± 0.5A | ||
| Overcurrent detection delay time | 5ms-15ms | ||
| Restore state | Automatic recovery | ||
| 6 | Short circuit protection | Detection Status | External short circuit |
| Detection delay time | ?50us | ||
| Restore state | Automatic recovery | ||
| 7 | Resistance | Protection lines (MOS-FET) | ?40m? |
| 8 | temperature | Operating temperature range | -40 ~ + 50 ? |
| Storage temperature range | -40 ~ + 90 ? | ||
| 9 | Size (L * W * H) | 22 * 4 * 3mm | |
Notes:
* Board is using DW01-P Chip to control the cells with 1x FS8205A MOSFETs. I found the datasheets and put them above.
* After connecting the cells may need to connect the charger to activate the board
* Before connecting cells in parallel, equalize the voltage with 1 ohm resistors between. May need from few minutes to few hours.
Be the first to review “3.7V lithium battery protection board overcharging over discharge current of 2A apply lithium polymer battery”
You must be logged in to post a review.
There are no reviews yet.