Currently Empty: €0,00
-€6,18
MKS TMC2100 Stepper Motor Driver Board with Heat Sink for 3D Printer
€13,33
Attualmente disponibile su ordinazione con consegna prevista entro 60 giorni circa dall'acquisto.
| Quantità | Prezzo Unitario |
|---|---|
| 12 - 49 | €12,93 |
| 50 - 99 | €12,66 |
| 100 + | €12,00 |
Product Description
MKS TMC2100 Stepper Motor Driver Board with Heat Sink for 3D Printer
Product Features
- Ultra-silent excellent stability
- Higher operating temperature, it is 0.5A operating temperature of about 70 degrees and 1A working temperature exceeds 150 degrees without the addition of the fan case, it is possible to lose steps, the best operating current around 0.5A
- The calculation method of driver current:i=Vref*1.9/2.5
- Default Vref is 0.65v, Default Current is 0.5a max current is 1A.
Product Description
Note:
TMC2100 Motor direction is contrary to A4988 and Drv8825 , if you want to replace them,please set the ajust firmware or adjust stepper motor wire connection.
Please do not connect to the motor while measuring voltage otherwise it may be easily burnt.
Please switch on the power supply instead of USB connected only while measuring voltage .
Please pay attention to the direction of the driver .
Please remove the 3 jumper caps first before you use on Ramps1.4 or MKS Gen.
Be the first to review “MKS TMC2100 Stepper Motor Driver Board with Heat Sink for 3D Printer”
You must be logged in to post a review.
There are no reviews yet.